Often, you end up paying a company to do an expensive and messy job that leaves your pool in worse shape than it was before. The good news is that you can find a leak in your pool yourself, if you know how to look for one. This article will talk about the most common leak locations in a swimming pool and how to use a few simple techniques to locate them.
The first thing you need to understand is that water loss from a pool can occur for a variety of reasons, not just because there is a leak somewhere.It is important to pool leak detection gather as much information as possible before you start attempting 4900 W. Eldorado Pkwy, Suite 148 to pinpoint the source of the loss.Look for boggy spots of grass, changes in the tile line around the pool or movement in the United States of America soil underneath the pool. Any of these may indicate a problem that needs to be addressed before it gets out of control.
A common leak location in a vinyl liner pool is a tear in the pool liner. Tears in the liner are often caused by sharp objects such as thorns, sticks and rocks that become stuck under the liner and eventually break through.They can also be caused by sagging or (214)-213-4637 damage to McKinney the vinyl liner that is not fixed in time.The best way to locate a tear is to carefully enter Texas the pool wearing goggles and use a pH tester kit. Carefully squirt the pH testing liquid over any area where you suspect there is a tear. If the acidic solution sucks in, you have located a tear and should make a patch to correct it.
Another common leak location is a faulty main drain. A leaking main drain is usually caused by one of two things: a broken valve or a blockage in the port. If the valve is broken, a new one will need to be installed. If the blockage is in the port, a hydrostatic relief valve is needed to be installed.
Other common leaks are around the skimmer, light and return fittings. The skimmer, for example, is frequently the site of small holes and cracks that can leak. Using the dye leak test and paying close attention to where the dye moves will help you determine if there is a problem with your skimmer.
Inground Leak Locations
An inground pool leak is more difficult to locate than a vinyl liner pool, but it can still be done. To begin, you will want to look for any puddles that could indicate a leak in the plumbing. Once you have identified any puddles, you will need to perform a leak test on the pool’s plumbing system.
If the puddles are on the bottom of the pool and you have determined that there is a leak in the plumbing, then it will be necessary to dig down to the point where the leak is occurring. Be sure to mark the spot where you see the puddles with waterproof tape so that you can find it again when digging
